saving . . . saved Oscad Schematic has been deleted. Oscad Schematic has been hidden .
Oscad Schematic
Whenever I try using IPRINT in my circuit  as an ammeter,,I face the following problems:

1. Issues regarding the grounding,sometimes it does not accept simple gnd/gnd with pwr flag and the troubleshooting becomes impossible.

2. Even if the circuit passes ERC check,during simulation in the ngspice window,it shows some iteration where the message says gmin value reached and no proper results are obtained.

Please help me with this as I am not able to proceed wit even simple RC circuits.

Oscad Schematic-Creation-and-Simulation 05-06 min 30-40 sec 26-03-14, 10:09 a.m. RAHUL SRIVASTAVA


1. Can you please be more specific? Can you tell us the error on the terminal?
2. Don't worry about gmin issue
26-03-14, 10:29 a.m. rakhiwarriar

I have mailed you alongwith attatched images of schematic and simulation.Hope you find a solution.
26-03-14, 6:43 p.m. RAHUL SRIVASTAVA

Log-in to answer to this question.