eSim - Electrical rule check of schematic

saving . . . saved Electrical rule check of schematic has been deleted. Electrical rule check of schematic has been hidden .

Electrical rule check of schematic

Title

Question

I have created schematic of practice problem1 of 3 days eSim workshop. I had copied 3 transistors from component library, one of which I deleted. But while doing electrical rule check, I am getting error saying " pin not connected for Q3 " whereas there are only two transistors. Shall I proceed ignoring the error?

eSim Schematic-Creation-and-Simulation 07-08 min 40-50 sec 12-02-21, 9:45 a.m. vijayc117

Answers:

yes, as long as there is no component pin left unconnected( denoted by a small green square), its ok. you can ignore them

12-02-21, 10:05 a.m. Saurabhb17

Title

Question

Answers:

Log-in to answer to this question.